Home » Door Rollers and Track Caps » #471- Miller Door Roller Assembly

#471- Miller Door Roller Assembly

Posted in Door Rollers and Track Caps, Doors, Extruded Roller Asssemblies, Sliding Glass Doors

Click here to enlarge

The Miller Door Roller Assembly allows you to easily operate a sliding glass door. This door roller assembly is used by various manufacturers including Miller Industries. The roller is made with extruded aluminum housing and a 1-1/4 in. diameter steel wheel.

Allows you to easily operate a sliding glass door
Used by various manufacturers including Miller industries
Made with an extruded aluminum housing and a steel wheel
1-1/4 in. diameter steel wheel

Details
Depth	2.25 in.
Height	1.5625 in.
Width	0.75 in.
Material	Aluminum
Weight	0.28 lb.

Installation Instructions/Instrucciones para la Instalacion

To remove door, open completely, lift up and tilt out.
To remove roller, remove mounting screw. If you have a second mounting screw, you may have to remove the bottom door frame by carefully tapping it off. Replace roller and install mounting screws. Place vinyl “u” channel back on glass and tap bottom frame back in place.
Adjust rollers by turning the adjustment screw in the back of the roller and adjust handle strike if necessary.

Para remover la puerta, abra completamente, levanter y gire hacia afuera.
Para remover el rodillo, remueva el tornillo de montaje. Si tiene un segundo tornillo de montaje, es posible que tenga que quitar el marco inferior cuidadosamente tocandolo suavemente. Cambie el rodillo e instale los tornillos de montaje. Re-instale vinilo tipo “u” en el vidrio y monte el marco inferior.
Ajuste los rodillos rotando el tornillo de ajuste en la parte trasera del rodillo y ajuste el mantenedor de la cerradura si fuera necesario.

Buy It On-Line